Heating cable with thermostat Entrade QsanTecVK75T

The heating cable is semi-rigid/malleable and suitable for use outdoors and in other locations that can withstand high temperatures.
(Installation only on metal surfaces. Not for heat tracing on plastic pipes.)
The heating cable is thermostat-controlled with a heating activation temperature of +3°C (+/-2°C).
The heating section starts 1.5 meters from the label, with a power output of 50 W/meter.
All electrical connections must be made with the power switched off.
The cable is connected to terminals L and N, preferably the same connections as the heat pump’s power supply.
If no dedicated power supply connection is available, use terminals 1 and 2.
Always check with the manufacturer that this connector can be used.
The thermostat must be positioned so that heat from the compressor does not affect it.
Ensure that the cable is not pinched, which could damage the insulation.
Remove the top and front covers before installing the cable. Wearing gloves is recommended to avoid cuts.